Electrical system
TABLE Q - REAR LAMBDA PROBE
•
Connect the rear lambda probe con-
nector correctly, then secure the probe
wiring harness (2) using a clip (1).
TABLE Q1 - REAR LAMBDA PROBE
•
Using a clip (3), fasten the rear lambda
probe wiring harness (2) to the saddle
support frame.
Back side
TABLE A - REAR BRAKE SWITCH-REAR ABS
SENSOR
•
Secure the rear ABS sensor wiring har-
ness (1) using the cable clamp (2)
mounted on the brake calliper support.
TABLE A1 - REAR BRAKE SWITCH-REAR ABS SENSOR
•
Secure the ABS sensor wiring harness (1) to the rear brake pipe (3) using the cable clamp
(4), and then route it through the plastic cable clamp (5) mounted on the swingarm.
ELE SYS - 100
SHIVER 900