APRILIA SHIVER 900 Service Station Manual page 273

SHIVER 900
•
Remove the bushings with the crank-
case cold, using a press and the spe-
cific tool and pushing inward from the
outside of the crankcase.
Specific tooling
020726Y Bushing extractor
Installing
•
The orientation of the semi-bushings
must match the specifications indica-
ted in the drawing as closely as possi-
ble.
NOTE
WHEN REPLACING THE SEMI-BUSHINGS ALONE, THE
NEW COMPONENTS MUST BE THE SAME COLOUR AS
THE REMOVED COMPONENTS. IF THE COLOUR OF THE
OLD COMPONENTS IS NO LONGER VISIBLE, USE THE
TABLE TO IDENTIFY THE CORRECT COMPONENTS, RE-
FERRING TO THE CRANKCASE AND CRANKSHAFT
CLASSES.
Key:
* Semi-bushing joint line.
•
Fit the new bushings with the crank-
case cold, using a press and the spe-
cific tool and pushing outward from the
inside of the crankcase, until the punch
comes into contact with the crankcase
surface.
Specific tooling
020727Y Bushing punch
Assembling the connecting rod
CAUTION
TO FIT THE CONNECTING RODS, CHECK THE COUPLING TYPES INDICATED IN THE "CRANK-
CASE- CRANKSHAFT CONNECTING ROD" SECTION, IN THE "CHARACTERISTICS" CHAPTER
OF THE WORKSHOP MANUAL.
Engine
ENG - 273