SHIVER 900
•
HW number/ - (indicates the Hardware number)
•
Approval number / -
•
Author of the latest progr. / - (author of the latest programming)
•
Mapping / - (indicates the mapping number)
•
Programming date / - (control unit programming date)
•
NIP code / - (internal code identifying the control unit)
•
VIN / - (vehicle identification number
DIAGNOSTIC TOOL:PARAMETERS AND STATUSES
PARAMETERS:
•
Engine rpm / - (engine rpm)
•
Air temperature / - (indicates the air temperature)
•
Water temperature/ - (indicates the water temperature)
•
Throttle valve angle / - (throttle vale opening angle)
•
Actuated advance / - (value of the real advance, seen from the control unit)
•
Injection time / - (indicates the electric injector opening time)
•
Battery voltage / - (indicates the battery voltage)
•
Lambda probe control / - (indicates the lambda probe correction percent)
•
Lambda probe voltage / - (indicates the value of the lambda probe voltage)
•
Atmospheric pressure / - (indicates the atmospheric pressure)
•
Objective minimum speed / - (minimum rpm required by the control unit)
•
Stepper CI.Loop Opening / - (Stepper Closed Loop opening)
•
Intake manifold pressure / - ( measure at the intake manifold)
•
Scheduled advance / - (value of the desire advance for the control unit)
•
Vehicle speed / - (indicates the actual speed of the vehicle)
•
Lambda adaptive gain / - (lambda adaptive gain)
•
Stepper equiv. throttle valve / - (stepper equivalent throttle valve angle)
•
Base Stepper opening / - (base stepper opening)
•
Stepper regulat. opening / - (stepper regulator opening)
•
KON count / - (key ON count)
•
Coil Dwell / -
•
Injector bleed / -
STATUSES:
•
Engine status / - (indicates the engine status)
•
Throttle valve status / - (indicates if the throttle valve is open or closed)
•
RUN - OFF switch / -
•
Start enable / - (indicates if the control unit allows the start up)
•
Ratio control status / -
Electrical system
ELE SYS - 127