APRILIA SHIVER 900 Service Station Manual page 213

SHIVER 900
Selector plate spring
With a thickness gauge, check that the spring is
not deformed by over-stretching.
Gearbox Selector Shaft
Removal
•
Place the left hand crankcase in a
press and extract the roller cage with
the specific tool.
NOTE
REPEAT THE SAME OPERATION FOR THE RIGHT HAND
CRANKCASE HALF.
Specific tooling
020724Y Punch cage with rollers gearbox con-
trol stem
INSTALLATION
•
Place the left hand crankcase in a
press and install the roller cage with the
specific tool.
CAUTION
TO INSTALL THE ROLLER CAGE IN THE RIGHT HAND
CRANKCASE HALF, WORK WITH THE CYLINDER ON THE
SIDE OF THE 1 mm (*) STEP ON THE TOOL TURNED TO-
WARD THE ROLLER CAGE, WHEREAS TO INSTALL THE
CAGE IN THE LEFT HAND CRANKCASE HALF, USE THE
CYLINDER ON THE SIDE OF THE 2 mm (**) STEP ON THE
TOOL.
Specific tooling
020724Y Punch cage with rollers gearbox con-
trol stem
Engine
ENG - 213