APRILIA SHIVER 900 Service Station Manual page 417

SHIVER 900
•
Detach the cable clamp (42) from the
base of the filter box.
•
Remove the four clamps positioned on
the front part of the filter box (43) and
release the wiring harness.
NOTE
DURING REASSEMBLY, REPLACE THE CLAMPS IN THE
POSITIONS IDENTIFIED BY THE GREY TAPE.
•
Working on both sides, loosen the metallic clamps (44) that fasten the filter box rubber
manifolds to the aluminium manifolds on the heads.
NOTE
DURING REASSEMBLY, MAKE SURE THAT THE METALLIC CLAMPS ARE POSITIONED COR-
RECTLY SO AS TO GUARANTEE THEY ARE TIGHTENED PROPERLY WHEN REPOSITIONING
THE FILTER BOX.
•
Raise the filter box slightly and discon-
nect the gear sensor connector (45)
and the engine oil temperature sensor
(46) from their supports.
•
Disconnect the two front/rear breather
tubes (47) from the filter box.
Bodywork
BODYW - 417