APRILIA SHIVER 900 Service Station Manual page 373

SHIVER 900
•
Unscrew the five screws (1) used to
fasten the brake disc and remove
them.
•
Remove the phonic wheel (2) and the
brake disc (3).
DURING REFITTING, APPLY LOCTITE 243 ON THE
THREAD OF THE BRAKE DISC SCREWS (1).
CAUTION
DURING REFITTING, SCREW ALL THE SCREWS (1) MAN-
UALLY AND TIGHTEN THEM OPERATING DIAGONALLY
FOLLOWING THIS SEQUENCE: A-B-C-D-E.
See also
Rimozione
Disc Inspection
CAUTION
THE BRAKE DISC SHAPE DOES NOT CHANGE THE OPERATING AND MAINTENANCE SPECI-
FICATIONS OF THE SYSTEM.
•
The following operations are to be car-
ried out with brake disc fitted on the
wheel.
•
Check the disc for wear by measuring
the minimum thickness with a micro-
meter in different points. If the mini-
mum thickness, even in a single point
of the disc, is less than the minimum
value, replace the disc.
Disc thickness minimum value: 4.5 mm (0.18
in)
Braking system
BRAK SYS - 373