APRILIA SHIVER 900 Service Station Manual page 323

SHIVER 900
•
Using a dial gauge, check that the ra-
dial (A) and the axial (B) eccentricities
of the rim do not exceed the limit value.
An excessive eccentricity is usually
caused by worn or damaged bearings.
Replace the rim if, after replacing the
bearings, the value is not within the
specified limit.
Characteristic
Maximum radial and axial eccentricity:
2 mm (0.0079 in)
Rear wheel
Pos. Description
1 Wheel axle nut
2 Button head, hex. socket screw used
for fastening the sensor to the brake
calliper support
3 DAX nut for fastening the crown gear
on the hub
4 Cyl. head, hex. socket screws used
for fastening the cush to the wheel
5 Flanged, hex. head screws used for
fastening the brake disc to the wheel
R
EAR WHEEL
Type Quantity
M25x1.5 1
M5x16 1
M10x1.25 5
M10x30 5
M8x18 5
Torque
120 Nm (88.51 lb ft)
6 Nm (4.43 lb ft)
50 Nm (36.88 lb ft)
50 Nm (36.88 lb ft) Pre-impregnated
30 Nm (22.13 lb ft) Pre-impregnated
Chassis
Notes
-
-
-
screws
screws
CHAS - 323