SHIVER 900
•
Remove the external screw used for
fastening the tail fairing to the side fair-
ing.
•
Remove the two internal screws used
fro fastening tail fairing to the side fair-
ing and separate them.
•
If necessary, in order to remove the ig-
nition switch assembly, disconnect the
saddle opening cable and remove it.
Copertura terminale
•
Remove the saddle, the rear grab-bar,
the rear light assembly and the number
plate support in order to remove the
terminal covers.
The following operations refer to a single cover,
but are valid for both:
•
Remove the lower fastening screw (1)
and retrieve the "T" bushing with the
rubber grommet.
Bodywork
BODYW - 435