APRILIA SHIVER 900 Service Station Manual page 124

Electrical system
Rear light
Characteristic
Rear daylight running light /stop light
12V - 5/21W x 2
Fuses
It is necessary to check the fuses whenever an electrical component fails to operate or malfunctions or
when the engine does not start.
Check the auxiliary 15A fuses first, then the main 30A fuse.
CAUTION
DO NOT ATTEMPT TO REPAIR FAULTY FUSES.
NEVER USE A FUSE THAT IS DIFFERENT THAN WHAT IS SPECIFIED TO PREVENT DAMAGES
TO THE ELECTRICAL SYSTEM OR SHORT CIRCUITS, AND THE RISK OF FIRE.
NOTE
A FUSE THAT BLOWS FREQUENTLY MAY INDICATE A SHORT CIRCUIT OR OVERLOAD.
SECONDARY FUSES
Before replacing the fuse, find, if possible, the
cause of the problem.
To check the secondary fuses:
•
To avoid an accidental short-circuit,
place the power switch to "OFF".
•
Remove the rider saddle.
•
Open the cover of the secondary fuse
box (1).
•
Take out one fuse at a time and check
whether the filament (2) is broken. In
this case change the fuse with one of
the same amperage.
NOTE
IF THE SPARE FUSE IS USED, REPLACE WITH ONE OF
THE SAME TYPE IN THE CORRESPONDING FITTING.
ELE SYS - 124
SHIVER 900