APRILIA SHIVER 900 Service Station Manual page 98

Electrical system
TABLE O1 - SIDE STAND
•
Install the side stand and route the side
strut sensor wiring harness (1) as indi-
cated, fastening it to the gear sensor
(4) wiring harness using a clamp (3).
TABLE O2 - SIDE STAND
•
Check that the side stand connector (5)
is connected correctly and fasten the
wiring harness to the flywheel wiring
harness cable clamp using a clamp (6).
TABLE O3 - SIDE STAND
•
After twisting the wiring harness, feed
it into the cavity inside the frame.
ELE SYS - 98
SHIVER 900