Braking system
Installing
•
Insert two new pads, placing them so
that the holes are aligned with the cal-
liper holes.
CAUTION
ALWAYS REPLACE BOTH PADS AND MAKE SURE THEY
ARE CORRECTLY POSITIONED INSIDE THE CALLIPER.
•
Screw the pin.
•
Install the safety circlip.
Bleeding the braking system
PREPARING THE VEHICLE
•
It is important to ensure that there is always a sufficient quantity of brake fluid in the tank.
•
These operations may be simplified by using a bleeding device when carrying out the "Re-
placing the brake fluid" operations
•
In this case, when performing the bleeding procedure, it is also necessary to operate the
brake pedal a few times with the bleeder device connected (approximately five times for
each wheel circuit).
REPLACING THE BRAKE PUMP
PRELIMINARY OPERATIONS
BRAK SYS - 378
SHIVER 900