APRILIA SHIVER 900 Service Station Manual page 330

Chassis
•
Remove the rear wheel.
•
Support the vehicle by means of the
engine service stand and a hoist with
belts fastened to the rear section of the
frame.
•
Remove the rear service stand.
•
Undo and remove the two lower swing-
arm screws.
•
Remove the cable guide.
•
Slide off the rear calliper holding plate,
keeping it linked to the brake pipe.
CAUTION
DO NOT ACTUATE ON THE REAR BRAKE LEVER AFTER
REMOVING THE WHEEL. OTHERWISE, THE CALLIPER
PLUNGERS COULD GO OUT OF THEIR SEAT, RESULTING
IN BRAKE FLUID LEAKAGE.
See also
Removing the
rear wheel
•
With the specific box-spanner, un-
screw and remove the locking ring nut.
•
Working from the left side, unscrew
and remove the nut and collect the
washer.
REMOVAL SHOULD BE CARRIED OUT WITH UTMOST
CAUTION.
SUPPORT THE SWINGARM FROM THE FRONT TO AVOID
ACCIDENTAL FALLS.
PLACE A WOODEN SUPPORT UNDER THE FRONT PART
OF THE REAR SWINGARM TO PREVENT IT FROM LOW-
ERING AND TO KEEP IT UPRIGHT.
See also
CHAS - 330
SHIVER 900