Electrical system
TABLE B - ENGINE EARTH
•
It is important to respect the output di-
rection of the battery earth (1), main
wiring harness earth (2) and engine
wiring harness earth (3) cables.
•
After fitting an elastic washer and the
appropriate screw, tighten the latter,
applying the pre-defined torque.
CAUTION
IF THE SCREW IS NOT FASTENED CORRECTLY IT MAY
CAUSE THE VEHICLE TO CATCH FIRE
TABLE C - RELAYS ON FILTER BOX
•
Arrange the relays on the right hand
side of the filter box, in accordance with
the coloured reference indicators.
•
The highbeam headlight relay (1),
identified by the white tape, must be
secured to the respective fastening
point using the rubber support.
•
The headlight relay (2), identified by
the red tape, must be secured to the
respective fastening point using the
rubber support.
•
The secondary injection relay (3), iden-
tified by the blue tape, must be secured
to the respective fastening point using
the rubber support. The wiring harness
must be routed behind the blow-bay
vapour recovery pipe.
TABLE C1 - RELAYS ON FILTER BOX
ELE SYS - 90
SHIVER 900