Cooling system
•
Remove the cap.
•
Empty the system into the specific con-
tainer.
•
Loosen the screw and move the clamp.
•
Slide off the sleeve and empty the sys-
tem completely.
CAUTION
SHOULD GREASE BE NOTED IN THE WATER THIS IS TO
BE CONSIDERED NORMAL BECAUSE DURING THE AS-
SEMBLY PHASE OF THE WATER PUMP SIGNIFICANT LU-
BRICATION OF THE SAME IS REQUIRED IN ORDER TO
PREVENT DAMAGE.
•
Refit both sleeves, place the corresponding clamps and tighten their screws.
•
Fill the expansion tank up to the marked level.
•
After bleeding the air from the tank, fit the expansion tank cap.
•
Refit the front protection and tighten the screw.
•
Fit the right side fairing.
COOL SYS - 392
SHIVER 900