APRILIA SHIVER 900 Service Station Manual page 235

SHIVER 900
Pos. Description
1 Special head cover fastening screw
Pos. Description
1 Water Temperature Sensor
2 Threaded plug
3 Nut for fastening the stud bolts to the
head - Pre-tightening
3 Nut for fastening the stud bolts to the
head - Tightening
4 Head / Cylinder / Crankcase fasten-
ing outside
5 Head / Cylinder / Crankcase fasten-
ing inside
6 Nut for fastening the Stud bolts to the
Head
7 Nut for fastening the Stud bolts to the
Head
8 Screw for fastening the connector to
the discharge
9 Water vent connector
H
EAD COVER
Type Quantity
M6 8
H
EAD
Type Quantity
M12x1.5 1
M12x1.5 1
M10x1.25 8
M10x1.25 8
M6x75 2
M6x125 4
M6 4
M8x1.25 2
M5 4
M6 1
Torque
9 Nm (6.64 lb ft)
Torque
20 Nm (14.75 lb ft)
10 Nm (7.38 lb ft) Loct. drise AL 506
13 Nm (9.59 lb ft) Lubricate the
threads before tight-
135° + 135°
13 Nm (9.59 lb ft)
13 Nm (9.59 lb ft)
12 Nm (8.85 lb ft)
25 Nm (18.44 lb ft)
6 Nm (4.43 lb ft) Loct. dry loc 2040
3 Nm (2.21 lb ft) Loct. 262
Engine
Notes
-
Notes
-
ening
-
-
-
-
-
ENG - 235