APRILIA SHIVER 900 Service Station Manual page 107

SHIVER 900
TABLE A5 - ENGINE WIRING HARNESS ON
THROTTLE BODY AND FILTER BOX
•
Fit the filter box side cover, position the
engine wiring harness (1) using the
grey reference point that can just be
distinguished from outside the cover.
TABLE A6 - ENGINE WIRING HARNESS ON
THROTTLE BODY AND FILTER BOX
•
Connect the engine wiring harness
connector (8) to its support (9) and
check that it has been coupled correct-
ly to the base of the filter box.
TABLE A7 - ENGINE WIRING HARNESS ON
THROTTLE BODY AND FILTER BOX
•
Connect the coil wiring harnesses to
the filter box, using the clamps (10)
positioned at the points indicated by
the grey tape.
CAUTION
THE CLAMPS POSITIONED ON THE LOWER PART OF THE
FILTER BOX MUST BE MOUNTED SO THAT THE "HEAD"
IS FACING DOWNWARDS AND RESTING AGAINST THE
WALL OF THE FILTER BOX.
TABLE A8 - ENGINE WIRING HARNESS ON
THROTTLE BODY AND FILTER BOX
•
Take care to position the branch from
the wiring harness next to the connec-
tor and not externally.
TABLE A9 - ENGINE WIRING HARNESS ON THROTTLE BODY AND FILTER BOX
•
Attach the cable clamp (11) already mounted on the coil wiring harnesses to the base of the
filter box, in correspondence with the holes.
Electrical system
ELE SYS - 107