APRILIA SHIVER 900 Service Station Manual page 163

SHIVER 900
•
Short-circuit to positive: disconnect the coil connector, turn the key to ON, activate the coil
with the diagnostic tool and check the voltage at PIN 27 of the connector: if there is voltage,
restore the wiring harness, if the voltage is 0, replace the coil.
•
If open circuit, short circuit to negative: check the electrical characteristics of the coil: if not
ok, replace the coil; if ok, perform the check procedure for the coil connector and for the
Marelli control unit connector; if not ok restore; if everything is ok, check the continuity of the
cable between the two ends of the cable: if there is no continuity, restore the wiring harness;
if there is continuity, with key ON, check the cable ground insulation (from the coil connector
or control unit connector); if not ok, restore the wiring harness.
Throttle body
Function
Sends to the injection control unit the throttle position and activates the throttle according to the control
unit
Operation / Operating principle
All the unit internal components (potentiometer and electric motor) are contactless; therefore, no elec-
trical diagnosis is possible for the throttle body, but for the circuits connected to it only.
Level in electrical circuit diagram:
Throttle check and handle grip sensor (Demand)
Position:
•
on the vehicle: inside the filter box
•
connector: on the throttle body, in lower position, near the throttle motors
Pin out:
1. potentiometer signal 1
2. supply voltage + 5V
3. throttle valve control command (+)
4. potentiometer signal 2
5. throttle valve control command (-)
6. ground lead
DIAGNOSTIC TOOL:PARAMETERS
Front cylinder throttle valve correction
•
Example value with key ON: 0,0°
•
Example value with engine on: 0.4°
Reading the intake pressures, the system tries to balance the intake pressures through the front and
rear cylinder, operating on the throttle valves positions: an acceptable value should be between -0.5
and +0.5
Rear cylinder throttle valve correction
Electrical system
ELE SYS - 163