Neutral (Proximity) Switch Installation - Toro GrandStand 74534 Service Manual

Neutral (Proximity) Switch Installation

1. Loosely install the two screws and nuts that secure
the switch to the switch mounting bracket (Fig. 846).
Fig. 846
2. With the controls in the neutral position, position the
switch so the target printed on the body of the switch
is aligned with the bolt attached to the control lever
assembly (Fig. 847).
Fig. 847
36" & 40" Toro GrandStand Service Manual
3. Secure the position of the switch by tightening the
two mounting screws (Fig. 848).
DSCN-2305a
Note: Ensure the end of the bolt is within .070" ±
.020" (1.8 ± 0.5mm) of the switch body (Fig.
849).
A. .070" + .020" (1.8 + 0.5mm)
DSCN-2308a
ELECTRICAL
Fig. 848
A
Fig. 849
DSCN-2305a
DSCN-2329a
8
8-39