HYDRAULIC DRIVE SYSTEM
4. Raise the rear of the machine and secure with jack
stands (Fig. 534).
5. Release the parking brake.
6. Remove the 4 lug nuts and the wheel assembly (Fig.
535).
6
6-32
Fig. 534
DSCN-2811a
Fig. 535
DSCN-2805a
7. Thoroughly clean the area around the hydraulic
fittings to prevent debris from entering the system.
8. Mark the hoses and corresponding wheel motor
fitting ports so the hoses get connected back in their
original locations (Fig. 536).
Fig. 536
9. Position a drain pain under the wheel motor.
10. Disconnect both hydraulic hoses from the wheel
motor (Fig. 537).
Fig. 537
36" & 40" Toro GrandStand Service Manual
DSCN-2830a
DSCN-2833a