Toro GrandStand 74534 Service Manual page 27

CHASSIS
15. Install the 3 Bellville washers into the pivot tube (Fig.
028).
3
Note: Bottom: Crown Up / Middle: Crown Down /
Top: Crown up (Fig. 029).
3-8
Fig. 028 DSCN-3924a
Fig. 029
DSCN-0423a
16. Position the caster wheel and fork assembly up
through the pivot hub.
17. Secure the caster wheel and fork assembly with the
nut (Fig. 030).
Fig. 030
18. Tighten locknut until spring washers are flat (15 ft-lbs
/ 20 Nm) and then back off a 1/4 turn to properly set
the pre-load on the bearings.
19. Remove the plug from the side of the pivot hub (Fig.
031).
Fig. 031
36" & 40" Toro GrandStand Service Manual
DSCN-0360a
DSCN-0436a