Toro GrandStand 74534 Service Manual page 153

HYDRAULIC DRIVE SYSTEM
14. Place a drain pan under the wheel motor and
disconnect both hydraulic hoses from the wheel
motor (Fig. 492).
15. Cap the hose ends to prevent debris from entering
the system (Fig. 493).
Note: If the wheel motor is going to be reused, cap
the hydraulic fittings to prevent debris from
entering the system.
6
6-20
Fig. 492 DSCN-2834a
Fig. 493 DSCN-2840a
16. Loosen the jam nut securing the position of the fit-
tings, then remove the hydraulic fittings (Fig. 494).
Fig. 494
17. Remove the four bolts and nuts securing the wheel
motor to the frame, then remove the wheel motor
(Fig. 495).
Fig. 495
18. To service the wheel motor, refer to the Parker/Ross
Wheel Motor Service Manual (HY13-1512-006-M1/
US).
36" & 40" Toro GrandStand Service Manual
DSCN-2836a
DSCN-2843a