Toro GrandStand 74534 Service Manual page 104

4. Position the bolt, spacer, and washer into the control
handle (Fig. 317).
Fig. 317
5. Secure the link assembly to the control handle using
a flange nut (Fig. 318).
Fig. 318
36" & 40" Toro GrandStand Service Manual
6. Loosely install the cable eyelet to the link assembly
stud (Fig. 319).
Note: This nut will be tightened in a later step.
DSCN-3763a
7. Route the cable around the pulleys and secure to
the link assembly using the nut and jam nut, then
tighten the nut securing the cable eyelet (Fig. 320).
Note: Do not over tension the cable. The speed
control handle must move freely, without the
cable binding on the pulleys.
DSCN-3766a
CONTROLS
Fig. 319 DSCN-3770a
Fig. 320
DSCN-3774a
4
4-37