Toro GrandStand 74534 Service Manual page 163

HYDRAULIC DRIVE SYSTEM
4. Install the inlet fitting into the filter mount inlet port
(Fig. 528).
Note: Do not tighten the jam nut at this time.
5. Secure the suction hose to the inlet fitting, then
secure the position of the fitting with the jam nut (Fig.
529).
6
6-30
Fig. 528 DSCN-2916a
Fig. 529 DSCN-2913a
6. Apply a thin coat of hydraulic fluid to the rubber
gasket on the replacement filter (Fig. 530).
Fig. 530
7. Install the replacement filter to the filter mount (Fig.
531).
Fig. 531
36" & 40" Toro GrandStand Service Manual
DSCN-2956a
DSCN-2910a