Toro GrandStand 74534 Service Manual page 45

CHASSIS
24. Move the terminal cover off the positive cable com-
ing from the battery, then remove the nut and lock
washer securing the positive battery cable and red
wire eyelet to the solenoid (Fig. 100).
3
25. Unplug the clutch wires from the wiring harness,
then push the grommet and the electrical plug
connector down through the engine base (Fig. 101).
3-26
Fig. 100 DSCN-4030a
Fig. 101 DSCN-4035a
26. Remove the two wire harness clamps securing the
wire harness to the engine base. They are located
next to the clutch connector and under the starter.
27. Raise the rear of the machine just enough to remove
the tires.
28. Thoroughly clean the area around the hydraulic
fittings, then mark the motor fittings and hoses to
ensure they are returned to their original location
upon assembly (Fig. 102).
Fig. 102
29. Remove the four high pressure hoses from the
motors. Cap the hose ends and motor fittings to
prevent debris from entering the system (Fig. 103).
Fig. 103
36" & 40" Toro GrandStand Service Manual
DSCN-4043a
DSCN-4046a