Toro GrandStand 74534 Service Manual page 72

3. Remove the two screws securing the pivot shaft
inside the LH motion control lever (Fig. 197 & 198).
Fig. 197
Fig. 198
36" & 40" Toro GrandStand Service Manual
Note: Only one bolt will typically back out due to
both threading into the same inner rod. A #4
easy-out can be used to secure the pivot rod.
The bolt on the opposite side can then be
removed (Fig. 199).
DSCN-3649a
4. Remove the RH control lever assembly from the
control tower.
5. Remove the pivot rod from the motion control handle
(Fig. 200).
DSCN-3653a
CONTROLS
Fig. 199 DSCN-3647a
Fig. 200 DSCN-3616a
4
4-5