Lh Motion Control Lever Installation - Toro GrandStand 74534 Service Manual

CONTROLS
5. Remove the bolt and jam nut from the handle
assembly (Fig. 187).
4
6. Remove the two plastic bearings from the ends of
the control handle (Fig. 188).
4-2
Fig. 187 DSCN-3595a
Fig. 188
DSCN-3597a

LH Motion Control Lever Installation

1. Install a plastic bearing into each end of the control
handle (Fig. 189).
Fig. 189
2. Loosely install the bolt and jam nut to the handle
assembly (Fig. 190).
Note: The nut will be tightened in a later step.
Fig. 190
36" & 40" Toro GrandStand Service Manual
DSCN-3597a
DSCN-3599a