Neutral Switch - Left And Right; Parking Brake Switch - Toro Z MASTER 2000 Series Service Manual

Neutral Switch - Left and Right

Parking Brake Switch

Electrical: Service and Repairs
The neutral switch is a single pole plunger type switch (normally open) with
two terminals. When the plunger is depressed, the circuit closes and there is
continuity between the terminals.
Motion control levers in neutral position (OUT), the switch will have continuity
(closed).
Motion control levers in the operating position (IN), the switch will NOT have
continuity (open).
g336403
The parking brake switch is a single pole plunger type switch (normally open)
with two terminals. When the plunger is depressed (parking brake ON), the
circuit closes and there is continuity between the terminals. This allows battery
voltage to flow to the rest of the safety interlock system.
Parking brake ON, the switch should have continuity (closed).
Parking brake OFF, the switch should NOT have continuity (open).
g336405
Figure 86
Figure 87
Page 8–8 2000 Series Z MASTER® Service Manual
3438-778 Rev A