Hydraulic Filter Mount Replacement; Hydraulic Filter Mount Removal - Toro GrandStand 74534 Service Manual

Hydraulic Filter Mount Replacement

Note: Cleanliness is a key factor in a successful
repair of any hydraulic system. Thoroughly
clean all exposed surfaces prior to any type
of maintenance. Cleaning all parts by using
a solvent wash and air drying is usually
adequate. As with any precision equipment,
all parts must be kept free of foreign material
and chemicals. Protect all exposed sealing
areas and open cavities from damage and
foreign material.
Upon removal, all seals, O-rings, and gaskets
should be replaced. During installation, lightly
lubricate all seals, O-rings, and gaskets with
clean petroleum jelly prior to assembly.

Hydraulic Filter Mount Removal

1. Place an oil pan under the filter and remove the
hydraulic oil filter (Fig. 518).
Fig. 518
36" & 40" Toro GrandStand Service Manual
HYDRAULIC DRIVE SYSTEM
2. Remove the suction hose from the filter mount inlet
fitting (Fig. 519).
3. Remove the suction hose from the filter mount outlet
fitting (Fig. 520).
DSCN-2910a
Fig. 519
DSCN-2913a
Fig. 520 DSCN-2914a
6
6-27