Adjusting The Tracking - Toro GrandStand 74534 Service Manual

19. Pull the RH and LH slider spacers rearward as far as
possible (Fig. 333).
Fig. 333
20. Tighten the clamp assembly to secure the cable to
the slider assembly (Fig. 334).
Fig. 334
36" & 40" Toro GrandStand Service Manual

Adjusting the Tracking

Note: Determine the left and right sides of the
machine from the normal operating position.
1. While driving the machine, push both control levers
forward the same distance.
2. Check if the machine tracks to one side. If it does,
stop the machine and set the parking brake.
3. Release the operator cushion from the rear of the
machine.
4. Rotate the right cable adjustment to position the
right motion control in the center of the control
panel neutral lock slot. Then, rotate the left cable
adjustment in quarter-turn increments until the
DSCN-3812a
machine tracks straight (Fig. 335).
Note: Only adjust the left cable to match the left
wheel speed to the right wheel speed. Do
not adjust the right wheel speed as this will
position the right motion control lever out of
the center for the control panel neutral lock
slot.
A
B
DSCN-3811a
A. Left cable adjustment B. Right cable adjustment
CONTROLS
Fig. 335 fig. 55 G012898
4
4-41