Epos Sensor Block - MUTOH Kona 760 Service Manual

Service manual Kona cutting plotter
Part replacement
3.4.6

EPOS sensor block

Tools necessary
P2 screwdriver

Replacement procedure
Follow the procedure below to replace the EPOS sensor block.
Step 1:
Step 2:
Step 3:
50
Remove the following covers first:
Remove the following covers first
Side covers

Y-rail cover

Penhead cover

Refer to Cover removal on page 27
Disconnect the EPOS sensor flatcable from the PCB board.
AP-74380 - Revision 1.1