Test Sheet Verify Epos Alignment; Epos Alignment → Test Plot - MUTOH Ultima 850 Operation Instructions Manual

Mutoh Ultima Multi-Purpose Cutting Plotter - Operation Instructions

2.9. TEST SHEET VERIFY EPOS ALIGNMENT

2.9.1 EPOS Alignment
Verify Automatic EPOS Alignment workflow (From FW V2.00 onwards)
To verify the EPOS alignment, please follow the instructions below.
Step 1 : Power ON the Ultima cutting plotter and install a pen.
Step 2 : Press the [TOOL] key and select 'pen'.
Step 3 : Make sure levers are up.
Step 4 : Set speed = 30 cm/s, Force = 60 gr
Step 5 : Load media, delivered with the Ultima Cutting Plotter. Make sure the barcode is located at the
rear side of the unit.
Step 6 : Levers down. Make sure the pressure rollers are located outside your frame
Step 7 : Press the [TEST] key. The display will show the following message.
Step 8 : By pressing the [UP] or [DOWN] key select 'EPOS alignment --> test plot'. The Display on the
Operation Panel will show the following message.
Step 9 : Press the [ENTER] key. The laser of the Ultima cutting plotter will measure the box and will start
(re)drawing the image file.
Step 10 : Verify positioning of contour cutting.
To verify bar code reading, please follow the instructions mentioned below.
Notes :
In the box of the Ultima Cutting Plotter, there's a paper (Test
sheet verify epos alignment) delivered with the pattern on.
You can find the procedure also on the sheet.
Perform this test before you start contour cutting.
→
test plot
Testplot :
Quality check
→ SC-850 or SC-1400
Choose testfile
Testplot
EPOS alignment
→ test plot
Choose testfile
22
AP-75125, Rev 1.3 ; 20/10/04