Keysight U7233A Testing Notes page 34

3 Single-Ended Signals AC Input Parameters Tests
9
Table 2 Test Configuration Options
Configuration Option Description
Stop on error Enabling this error message will allow error message to prompt whenever criteria is not met. Disabling this option will allow the system
to bypass all the error messages that could occur and continue to the next test. This option is suitable for long hours multiple trial.
Signal Threshold setting This option allow user to define the Upper and Lower threshold of the signal by percentage.
by percentage
VDD Input supply voltage value.
VDDQ Input supply voltage for data output.
Vref Input reference voltage value.
Vih(DC) Input voltage high value (direct current).
Vih(AC) Input voltage high value (alternating current).
Vil(DC) Input voltage low value (direct current).
Vil(AC) Input voltage low value (alternating current).
InfiniiScan Limits
Read Cycle
IScan_UL_READ Identifies the upper limit for Setup Time measurement used in the InfiniiScan Measurement Mode (READ cycle)
IScan_LL_READ Identifies the lower limit for Setup Time measurement used in the InfiniiScan Measurement Mode (READ cycle)
Write Cycle
IScan_UL_WRITE Identifies the upper limit for Setup Time measurement used in the InfiniiScan Measurement Mode (WRITE cycle)
IScan_LL_WRITE Identifies the upper limit for Setup Time measurement used in the InfiniiScan Measurement Mode (WRITE cycle)
Single-Ended Signals
Single-Ended AC
Parameters
Pin Under Test, PUT Identifies the Pin Under Test for Single-Ended AC parameters.
PUT Source Identifies the source of the PUT to be analyzed for Single-Ended AC tests.
Supporting Pin Identifies the required supporting pin for Single-Ended AC parameters.
Supporting Pin Source Identifies the source of the supporting pin for Single-Ended AC Tests.
34
Follow the DDR1 Test Application's task flow to set up the configuration options (see
the tests and view the tests results.
DDR1 Compliance Testing Methods of Implementation
Table 2), run