Keysight X Series Installation Note
Agile signal generators
Hide thumbs
Also See for X Series:
- Programmer's reference manual (2650 pages) ,
- Measurement manual (225 pages) ,
- Manual (119 pages)
Related Manuals for Keysight X Series
Summary of Contents for Keysight X Series
- Page 1 Keysight UXG X-Series Agile Signal Generators Add SSD Accessories 1CC145A and 1CC150A Installation Note...
- Page 2 The information contained in this document is subject to change without notice. Keysight Technologies makes no warranty of any kind with regard to this material, including but not limited to, the implied warranties of merchantability and fitness for a particular purpose.
- Page 3 To Be Performed By: ..... . (X) Keysight Technologies Service Center (X) Personnel Qualified by Keysight Technologies (X) Customer Estimated Installation Time: ....
-
Page 4: Installation Kit Parts List
Contacting Keysight For assistance, get in touch with your nearest Keysight Technologies Sales and Service Office. To find your local Keysight office access the following URL, or if in the United States, call the following telephone number: http://www.keysight.com/find/assist... - Page 5 Check Signal Generator Functionality Check Signal Generator Functionality Use the following procedure to confirm that the signal generator powers up and the internal check identifies no errors. The internal check evaluates the operation of the signal generator and returns an error message if it detects a problem. When the signal generator is first connected to ac line power, Reference Oven Cold occurs which causes the OVEN COLD annunciator to turn on.
- Page 6 SSD must have a SATA III 6Gb/s interface and an operating temperature range equal to or greater than the operating temperature range of the instrument. Only drives purchased from Keysight Technologies are covered under warranty. Keysight does not warrant third party supplied hardware or software including third party SSDs.
- Page 7 1CC145A - Empty Drive Tray Accessory Installation If no SSD is desired in the instrument: 3. Install the empty drive tray by sliding the tray into the rear panel opening. Secure by tightening the thumb screw. Torque to 9 in-lbs. For a customer purchased SSD installation: 4.
- Page 8 1CC145A - Empty Drive Tray Accessory Installation 5. Refer to Figure 3. Install the SSD onto the tray using the same screws. Torque to 4 in-lbs. Figure 3 SSD Installation 6. Install the drive tray by sliding the tray into the rear panel opening. Press to mate with the connectors.
- Page 9 1CC150A - Additional SSD Drive Installation 1CC150A - Additional SSD Drive Installation 1. Disconnect the power cord. 2. Refer to Figure 4. Remove the Solid State Drive (1) by using the T-15 driver to loosen the thumb screws where indicated and pulling out of the rear panel. Figure 4 SSD Removal 3.
- Page 10 This information is subject to change without notice. © Keysight Technologies 2019 Edition 1, May 2019 www.keysight.com...