Table of Contents
Advertisement
4
5
Figure 63
6
7
DDR1 Compliance Testing Methods of Implementation
In the Probe Calibration dialog box, select the Calibrated Atten/Offset radio button.
Select the Start Atten/Offset Calibration... button and follow the on-screen instructions for the
vertical calibration procedure.
Probe Calibration Window.
Once the vertical calibration has successfully completed, select the Calibrated Skew... button.
Select the Start Skew Calibration... button and follow the on-screen instructions for the skew
calibration.
At the end of each calibration, the oscilloscope will prompt you if the calibration was or was not
successful.
Calibrating the Infiniium Oscilloscope and Probe
13
181
Advertisement
Table of Contents
