Table of Contents
Advertisement
Verifying the Connection
1
2
3
4
Figure 58
DDR1 Compliance Testing Methods of Implementation
On the Infiniium oscilloscope, press the autoscale button on the front panel.
Set the volts per division to 100 mV/div.
Set the horizontal scale to 1.00 ns/div.
Set the horizontal position to approximately 3 ns. You should see a waveform similar to that in
Figure 58
below.
Good Connection Waveform Example
Calibrating the Infiniium Oscilloscope and Probe
13
177
Advertisement
Table of Contents
