Configure[1]|2|3|4[:Scalar][:Power:ac]:Ratio Relative[<Expected_Value>[,<Resolution>[,<Source List>]]] - Keysight Technologies P Series Programming Manual

CONFigure[1]|2|3|4[:SCALar][:POWer:AC]:RATio:
RELative[<expected_value>[,<resolution>[,<source list>]]]
This command sets the measurement function, range and resolution of the
specified window. It sets the measurement function to ratio with relative mode on.
The relative value used is that set by the CALCulate:RELative:MAGNitude:AUTO
command.
Syntax
CONF
1
2
3
4
Parameters
Refer to
parameters in this command.
Item
expected_value
(for the expected power level)
resolution
source list
Keysight N8262A Programming Guide
:POW
:SCAL
expected_value
Space
DEF
"Optional Parameters"
Description/Defaul t
The power meter ignores the numeric value entered in
this parameter. Any value entered is treated like DEF.
A numeric value for the resolution. If unspecified the
current resolution setting is used.
This channel list specifies the channels used to
calculate the ratio.
If unspecified and the current window setup is a ratio
measurement then this ratio setup is used, otherwise it
defaults to Channel A/B.
:RAT
:AC
,
resolution
DEF
on page 126 for additional details on the
MEASurement Commands
:REL
,
source list
Range of Values
Sensor dependent
[a]
DEF
[b]
1 to 4
1.0, 0.1, 0.01, 0.001
[a]
DEF
(@1),(@2)
(@2),(@1)
(@1),(@1)
(@2),(@2)
2
143