Measure[1]|2|3|4[:Scalar][:Power:ac]? [<Expected_Value>[,<Resolu Tion>[,<Source List>]]] - Keysight Technologies P Series Programming Manual

2 MEASurement Commands
MEASure[1]|2|3|4[:SCALar][:POWer:AC]?
[<expected_value>[,<resolution>[,<source list>]]]
This command sets the specified window's measurement function to single
channel with relative mode off, aborts, configures the window then initiates
Channel A or B, calculates the measurement result and places the result on the
bus.
Syntax
MEAS
1
2
3
4
Parameters
Refer to
parameters in this command.
Item
expected_value
(for the expected power level)
resolution
source list
172
:POW
:SCAL
expected_value
Space
DEF
"Optional Parameters"
Description/Defaul t
A numeric value for the expected power level. The units of
measurement are dBm and W. The default units are defined
by UNIT:POWer.
A numeric value for the resolution. If unspecified the current
resolution setting is used.
The channel which the command is implemented on.
If unspecified the current window setup is used. However, if
the window shows a ratio or difference measurement, the
upper window defaults to Channel A and the lower window to
Channel B.
?
:AC
,
resolution
DEF
on page 126 for additional details on the
Keysight N8262A Programming Guide
,
source list
Range of Values
Sensor dependent
[a]
DEF
[b]
1 to 4
1.0, 0.1, 0.01, 0.001
[a]
DEF
(@1)
(@2)