Table 12-41 Nadc: Power Meter Presets - Keysight Technologies P Series Programming Manual

The following table shows the power meter presets when <character_data> is
set to NADC. Commands not listed are preset according to their DEFault values (for
further information refer to
Table 12-41 NADC: Power meter presets
Command
Frequency
[SENS[1]]|SENS2:FREQ[:CW|:FIX]
Sensor measurement mode
[SENS[1]]|SENS2:DET:FUNC
Sensor video bandwidth setup
[SENS[1]]|SENS2:BAND|BWID:VID
Gate Setup
[SENS[1]]|SENS2:SWE[1]|2|3|4:OFF:TIME
[SENS[1]]|SENS2:SWE[1]|2|3|4:TIME
Trigger setup
TRIG[:SEQ[1]|2]:SOUR
INIT:CONT
TRIG[:SEQ]:LEV:AUTO
TRIG[:SEQ]:LEV
TRIG[:SEQ]:SLOP
TRIG[:SEQ]:DEL
TRIG[:SEQ]:HOLD
[a]
Range
Keysight N8262A Programming Guide
Table 12-1):
Setting
+800.000 MHz
NORM
N1921/2A: OFF
µ
Gate 1: 123.5 s
Gate 2: 20.123 ms
Gates 3 - 4: 0
Gate 1: 6.46 ms
Gate 2: 6.46 ms
Gates 3 - 4: 0
INT1
ON
OFF
-15 dBm
POS
0 s
30 ms
SYSTem Subsystem
Comments
Frequency setting
Measurement mode
Sensor video bandwidth
Delay between trigger point and time
gated period.
Length of time gated period for time gated
measurements.
Trigger source set up and acquisition
mode continuous triggering
Disable automatic setting of the trigger
level
Power level
Trigger event recognized on the rising
edge of a signal
Delay between recognition of trigger event
and start of a measurement
Trigger holdoff
12
525