[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3 Commands
These commands control the pulse power measurement feature of the power
meter.
The following commands are detailed in this section:
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3[:INPut]
[:MAGNitude] <numeric_value>
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3:STATe <boolean>
You can use either DCYCLe or GAIN3 in these commands, both do the same.
NOTE
Using GAIN3 complies with the SCPI standard whereas DCYCle does not, but
may make your program more understandable.
Keysight N8262A Programming Guide
SENSe Subsystem
10
373