Keysight Technologies P Series Programming Manual page 127

Modular power meter

Hide thumbs Also See for P Series:

Table of Contents

The <resolution> parameter sets the resolution of the specified window. This

parameter does not affect the resolution of the remote data but it does affect the

auto averaging setting. Where a channel is set up in both the upper and lower

window and the <resolution> parameter settings for these windows are

different, the highest resolution setting is taken to calculate the averaging. If you

are making a ratio or difference measurement the <resolution> parameters are

applied to both channels.

The <source list> parameter is used to define:

– What channels the measurements will be made on, for a dual channel

– Whether the calculation is A-B or B-A, for a dual channel difference

– Whether the calculation is A/B or B/A, for a ratio measurement.

Enter a <source list> is required before you proceed.

The following commands are described in this chapter:

CONFigure[1]|2|3|4?

CONFigure[1]|2|3|4

Keysight N8262A Programming Guide

measurement.

Parameter Form

[<expected_value>

[,<resolution>[,<source list>]]]

[<expected_value>

[,<resolution>[,<source list>]]]

[<expected_value>

[,<resolution>[,<source list>]]]

[<expected_value>

[,<resolution>[,<source list>]]]

MEASurement Commands

[query only]

Chapters

Table of Contents