Calculate[1]|2|3|4:Limit Commands - Keysight Technologies P Series Programming Manual

Modular power meter

Hide thumbs Also See for P Series:

Table of Contents

CALCulate[1]|2|3|4:LIMit Commands

These commands set the limits on both the upper and lower windows/

measurements enabling you to:

– Set upper and lower level limits

– Query if there has been a failure

– Count the number of failures

– Clear the counter

The following commands are detailed in this section:

CALCulate[1]|2|3|4:LIMit:CLEar:AUTo <boolean>

CALCulate[1]|2|3|4:LIMit:CLEar[IMMediate]

CALCulate[1]|2|3|4:LIMit:FAIL?

CALCulate[1]|2|3|4:LIMit:FCOunt?

CALCulate[1]|2|3|4:LIMit:LOWer[:DATA]

CALCulate[1]|2|3|4:LIMit:UPPer[:DATA]

CALCulate[1]|2|3|4:LIMit:STATe <boolean>

Keysight N8262A Programming Guide

CALCulate Subsystem

Table of Contents