Query Example
CORR:GAIN2?
Error Messages
– If a loss/gain correction value is entered using
– The SENSe[1]]|SENSe2:CORRection:GAIN2[:INPut][:MAGNitude] command
Keysight N8262A Programming Guide
[SENSe[1]]|SENSe2:CORRection:GAIN2[:INPut][:MAGNitude] while
[SENSe[1]]|SENSe2:SPEed is set to 200, the error –221, "Settings Conflict"
occurs. However, the correction value is set but the
[SENSe[1]]|SENSe2:CORRection:GAIN2:STATe command is not automatically
set ON.
can be used for the 8480 Series Power Sensor when no sensor calibration
table has been set up.
This command queries the current setting of
the channel offset on Channel A.
SENSe Subsystem
10
385