Keysight Technologies P Series Programming Manual page 377

[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3:STATe <boolean>
This command is used to enable and disable the pulse power measurement
feature.
The [SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3 command should be used to
enter the duty cycle of the signal you want to measure.
Syntax
SENS
SENS2
Example
CORR:DCYC:STAT 1
Reset Condition
On reset, the pulse power measurement feature is disabled.
Query
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3:STATe?
The query enters a 1 or 0 into the output buffer indicating the status of the pulse
power measurement feature.
– 1 is returned when the pulse power measurement feature is enabled
– 0 is returned when the pulse power measurement feature is disabled
Keysight N8262A Programming Guide
:
1 CORR
:DCYC :STAT
:GAIN3
This command enables the pulse
measurement feature on Channel A.
SENSe Subsystem
Space
0|OFF
1|ON
?
10
377