Trigger[:Sequence[1]|2]:Count <Numeric_Value - Keysight Technologies P Series Programming Manual

TRIGger[:SEQuence[1]|2]:COUNt <numeric_value>
This command controls the path of the trigger subsystem in the upward traverse
of the wait for trigger state. COUNt loops through the event detection/
measurement cycle are performed. That is, COUNt measurements are performed in
response to COUNt trigger events.
COUNt can be set to a value >1 only when:
– [SENSe[1]]|SENSe2:MRATe <character_data> is set to FAST
and
– TRIGger[1]|2:SOURce set to BUS, IMMediate or HOLD.
Syntax
TRIG
Parameters
Item
numeric_value
Keysight N8262A Programming Guide
:SEQ
Description/Defaul t
The number of triggered events for the measurement cycle.
– DEF: the default value is 1
1
:COUN
2
TRIGger Subsystem
numeric_value
Space
DEF
?
Range of Values
1 to 50
DEF
14
597