Calculate[1]|2|3|4:Limit:upper[:Data] <Numeric_Value - Keysight Technologies P Series Programming Manual

3 CALCulate Subsystem
CALCulate[1]|2|3|4:LIMit:UPPer[:DATA] <numeric_value>
This command enters a value for the upper test limit for the specified window/
measurement used in the CALCulate[1]|2|3|4:LIMit:FAIL? test. The units
used are dependent on the current setting of UNIT:POWer and
CALCulate:RELative:STATe as shown in
greater than the value specified in CALCulate[1]|2|3|4:LIMit:UPPer[:DATA],
CALCulate[1]|2|3|4:LIMit:FAIL? reports a fail. When the measured level is less
than or equal to the limit, a fail is not reported.
Table 3-2 Measurement units
Measurement Mode
Single Channel
Ratio
Difference
Syntax
CALC
206
Measurement Type
Avg, Pk
Pk–Avg
Avg, Pk, Pk–Avg
Avg, Pk
Pk–Avg
:LIM
1
2
3
4
Table
CALC:REL:STAT OFF
Linear Log
Watt dBm
% dB
% dB
Watt dBm
% dB
:UPP :DATA
3-2. When the measured power is
CALC:REL:STAT ON
Linear
%
%
%
%
%
Space numeric_value
DEF
MIN
MAX
Space
?
Keysight N8262A Programming Guide
Log
dB
dB
dB
dB
dB
MIN
MAX