Editing Frequency Dependent Offset Tables - Keysight Technologies P Series Programming Manual

Editing Frequency Dependent Offset Tables

It is not possible to create any additional frequency dependent offset tables.
However, the 10 existing tables can be edited using the MEMory subsystem. To do
this:
1 Select one of the existing tables using:
2 Enter the frequency data using:
3 Enter the offset factors as shown in the table below using:
4 If required, rename the frequency dependent offset table using:
Keysight N8262A Programming Guide
MEMory:TABle:SELect <string>
For information on naming frequency dependent offset tables see
Frequency Dependent Offset Tables"
current names which you can select refer to
Offset Table Names"
MEMory:TABle:FREQuency <numeric_value> {,<numeric_value>}
MEMory:TABle:GAIN <numeric_value> {,<numeric_value>}
Frequency
Frequency 1
Frequency 2
"
Frequency n
MEMory:TABLe:MOVE <string>,<string>. The first <string> parameter
identifies the existing table name, and the second identifies the new table
name.
Power Meter Remote Operation
on page 81. For information on the
on page 80.
"Listing the Frequency Dependent
Offset
Offset 1
Offset 2
"
Offset n
1
"Naming
79