Example - Keysight Technologies P Series Programming Manual

Modular power meter

Hide thumbs Also See for P Series:

Table of Contents

MEASurement Commands

[a] The mnemonic DEF means DEFault. This is not equivalent to the DEFault parameter used in the command sub-systems. The parameters must

be entered in the specified order. If parameters are omitted, they default from the right. The parameter DEFault is used as a place holder.

Specifying DEF leaves teh parameter value unchanged.

[b] When the measurement result is linear this parameter represents the number of significant digits. When the measurement result is

logarithmic 1 to 4 represents of 1, 0.1, 0.01 and 0.001 respectively.

Example

CONF1:DIFF:REL DEF,1,(@1),

This command configures the upper window/

upper measurement to make a difference

measurement of Channel A - Channel B with

relative mode on, using the current sensor

range and a resolution of 1 on both channels.

Keysight N8262A Programming Guide

Table of Contents