Keysight Technologies P Series Programming Manual page 347

Modular power meter

Hide thumbs Also See for P Series:

Table of Contents

[SENSe[1]]|SENSe2:AVERage:COUNt <numeric_value>

This command is used to enter a value for the filter length. If

[SENSe[1]]|SENSe2:AVERage:COUNt:AUTO is set to ON then entering a value for

the filter length automatically sets it to OFF. Increasing the value of filter length

increases measurement accuracy but also increases the time taken to make a

power measurement.

Entering a value using this command automatically turns the

[SENSe[1]]|SENSe2:AVERage:STATe command to ON.

For most applications, automatic filter length selection

([SENSe[1]]|SENSe2:AVERage:COUNt:AUTO ON) is the best mode of operation.

However, manual filter length selection ([SENSe[1]]|SENSe2:AVERage:COUNt

<numeric_value>) is useful in applications requiring either high resolution or fast

settling times, where signal variations rather than measurement noise need

filtering, or when approximate results are needed quickly.

Keysight N8262A Programming Guide

SENSe Subsystem

Chapters

Table of Contents