Table of Contents
Advertisement
2
MEASurement Commands
Item
resolution
source list
[a] The mnemonic DEF means DEFault. This is not equivalent to the DEFault parameter used in the command sub-systems. The parameters must
be entered in the specified order. If parameters are omitted, they default from the right. The parameter DEFault is used as a place holder.
Specifying DEF leaves the parameter value unchanged.
[b] When the measurement result is linear this parameter represents the number of significant digits. When the measurement result is
logarithmic 1 to 4 represents of 1, 0.1, 0.01 and 0.001 respectively.
Example
CONF2:REL -50DBM,3,(@1)
136
Description/Defaul t
A numeric value for the resolution. If unspecified the current
resolution setting is used.
The channel which the command is implemented on.
If unspecified the current window setup is used. However,
if the window shows a ratio or difference measurement, the
upper window defaults to Channel A and the lower window
to Channel B.
Range of Values
1 to 4
1.0, 0.1, 0.01, 0.001
DEF
(@1)
(@2)
This command configures the lower window/
upper measurement to measure the relative
power of Channel A, using an expected
power level of –50 dBm and a resolution
setting of 3.
Keysight N8262A Programming Guide
[b]
[a]
Advertisement
Chapters
Table of Contents
