SERVice:SENSor[1]|2:FREQuency:MAXimum?
This query returns the maximum frequency that can be measured by the currently
connected sensor. It is applicable to E-Series sensors only. Maximum frequency
information is stored in the sensor's EEPROM.
Syntax
SERV
Example
SERV:SENS2:FREQ:MAX?
Error Messages
– If no sensor is connected, error –241, "Hardware missing" occurs.
– If a a sensor other than an E-Series power sensor is connected, error –241
– If the sensor, currently connected, does not contain the necessary information
Keysight N8262A Programming Guide
:SENS
"Hardware missing" occurs.
in EEPROM, error –241 "Hardware missing" occurs.
1
:FREQ
2
This query returns the maximum frequency
that can be measured by the E-Series sensor
currently connected to Channel B.
SERVice Subsystem
:MAX
?
16
633